The ppp multilink command is configured on the BRI interface.
CSCds42723 Cell-payload scrambling may be automatically turned off on an ATM interface when a router is reloaded even when cell-payload scrambling is enabled in the configuration.
An error indicating that command is not supported should be generated.But if the remote site does not pad the frame, the frame is dropped on the Ethernet as a runt.CSCds48844 Enabling Multilink PPP on some interfaces on a PA-MC-2T3 port adapter card together with distributed Cisco Express Forwarding (dCEF) may cause trace backs.Resolved CaveatsCisco IOS Release.1(3a)T8, resolved CaveatsCisco IOS Release.1(3a)T7, resolved CaveatsCisco IOS Release.1(3a)T6.CSCdt30424 When you unconfigure the map-class frame-relay global configuration command, the Cisco router may reload.CSCds60793 A Cisco 5300 series universal access server running Multilink PPP between Multiprotocol Label Switching/Virtual Private Network (mpls/VPN) provider edge (PE) and Content Engine (CE) devices does not work when only one link.In this case, the action group is unconditionally removed.CSCds42916 When running Enhanced Interior Gateway Protocol (eigrp) in a Multiprotocol Label Switching (mpls) network using XTagATM interfaces, a Tag Switch Controller (TSC) failed when an XTagATM interface was executed using the shut/no shut command in DSP configuration mode and then the clear ip eigrp.A change in the digital subscriber lines (DSLs) state through configuration (using the shutdown and no shutdown commands) does not restore the B-channel(s) to IN_service.This situation causes the Cisco router to miss the ring gutscheine für den freund die nichts kosten tone from the called party.The cmts will not allow you to destroy the profiles.CSCdr48618 Continuity Test (COT) in loopback mode fails in a Cisco router that is running Cisco IOS Release.1 PI.1.Exec and Configuration Parser CSCds55510 In Cisco IOS Release.1(5)T, a memory leak exists with the Route Download process.
CSCdr45798 isdn does not send the Called Party "Number Type" information received from the call switching module (CSM) in the outgoing setup message.
The reload is caused by an attempt to use the null pointer.